Garbage truck cylinder repair method Because garbage trucks travel in harsh environments, they are often prone to problems. It is an annoying thing to get a garbage truck broken. First, Pistons 1. The piston pin retainer is not installed or detached and is broken so that it can be pulled out during movement. It is also extremely easy to pull the cylinder wall. 2. The piston has more carbon deposits. Too much carbon deposit will cause the piston ring to stick or bite in the bad groove. Because the carbon deposit is hard abrasive, it will form a groove in the cylinder wall of the engine. 3. The opening clearance, side clearance, and back clearance of the piston ring are too small. When the garbage truck engine is working, the piston ring is heated to expand, and then snapped. Therefore, excessive pressure on the cylinder wall can cause the piston ring to break or cause the cylinder to break. Wall strained. 4. The misalignment of the piston cylinder. Poor quality of the piston, or a large error in its size, and deformation caused during the assembly process will make the gap smaller, and the piston will seize due to thermal expansion, thereby pulling the cylinder wall. 5. Due to the bent and twisted deformation of the garbage truck connecting rod. The parallelism and coaxiality of the piston pin seat are greatly deviated, and the phenomenon of eccentric cylinder is more serious. Finally, the wear of the piston ring, piston and cylinder wall is accelerated, and the formation of the oil film is damaged. Second, cylinder liner On the one hand, the cylinder liner is excessively worn, which reduces the seal between the piston and the cylinder liner. Part of the high-temperature gas slammed down from the cylinder, causing damage to the oil film between the piston and the cylinder, resulting in a cylinder accident. On the other hand, the cylinder is deformed during assembly. Can easily lead to cylinder accidents.
Model: XY-C800 XY-C1200
Specifications:
The tyre cutting machine is applied to cut all kinds of rubber blocks and strips,it is good for cutting rubber tyre,rail tyre, rubber strips etc.
Advantages:
1.This machine with large cutting knife,good shearing effect,fast cutting speed and low energy consumption;
2.Small size, easy to move;
3.Adopt hydraulic system, easy to operate and very safe design.
Tyre Cutter,Tyre Cutting Machine,Tire Cutting Machine,Tire Cutter Shangqiu Jinpeng Industrial Co., Ltd. , http://www.recyclingthewaste.com