Huaishu Peng, a doctoral student in information science at Cornell University, has developed an experimental technique that allows him to modify the 3D print structure through AR during robotic work. He called this system the Robotic Modeling Assistant (RoMA). In the demo video, Peng shows how to use RoMA to make a special structure and use an AR-based visual guide to sculpt objects. The combination of the AR and the robot allows the designer to use the newly printed part to design the next function. Designers can even design and print directly on existing objects, thus strengthening the process between design and manufacturing. Using AR to design structures and objects around real objects is a virgin land that has not yet been explored, and Peng said that he only touched the fur for the potential between AR and 3D printing. brief introduction Cyclone Dust Collector Cyclone Dust Collector,Industrial Cyclone Dust Collector,Woodworking Cyclone Dust Collector,Dust Collection Cyclone Dust Collector Botou Youjian Environmental Protection Equipment Co. LTD. , http://www.btdustmachine.com
The cyclone was used in 1885 and has developed into many forms. According to the way of air entry, it can be divided into two categories: tangential entry and axial entry. Under the same pressure loss, the latter can handle about 3 times the gas and the air distribution is even.
The Cyclone Dust Collector is composed of an intake pipe, an exhaust pipe, a cylinder body, a cone and a ash hopper. The cyclone Dust Collector is simple in structure, easy to manufacture, install and maintain management. The investment and operation cost of the equipment are low. It has been widely used to separate solid and liquid particles from the air or separate solid particles from the liquid. Under normal operating conditions, the centrifugal force acting on particles is 5~2500 times that of gravity, so the efficiency of cyclone separator is significantly higher than that of gravity settling chamber. Based on this principle, a cyclone dust removal device with a dust removal efficiency of more than ninety percent has been successfully developed. In the mechanical dust remover, the cyclone dust collector is the most efficient one. It is suitable for the removal of non - adhesive and non - fibrous dust. Most of them are used to remove particles above 5 m. The parallel multi tube cyclone device also has 80 to 85% dust removal efficiency for 3 - M particles. The cyclone duster constructed with special metal or ceramic materials with high temperature resistance, abrasion resistance and corrosion can operate at a temperature of 1000 degrees C and pressure of 500 x 105Pa. In terms of technology and economy, the control range of pressure loss for cyclone dust collector is generally 500 to 2000Pa. Therefore, it belongs to the medium effect dust collector, and can be used for the purification of high temperature flue gas. It is a kind of widely used dust remover, and it should be used in the dust removal of boiler flue gas, multistage dust removal and predusting. Its main drawback is the low removal efficiency of fine particles (<5, m).