Heat shrink Joints, Insulated waterproof connector terminals,Heat shrinkable butt connectors with inner PA adhesive, shrinking temperature 125℃,dielectric strength 14KV/mm,
waterproof connectors,solderless terminals,butt-connectors with shrinking tube insulation,Female disconnects,pin fork terminals KEYUACE Materials Co., Ltd. , https://www.insulationtubing.com
First remove the oil gauge to check if the engine oil is too thin. If the oil level of the engine oil is found to be high and it is lean, the cause should be further investigated to see if there is water or fuel leaking and dilute the engine oil, causing excessive dilution. The inspection method is as follows.
Pull out the oil ruler, drop a few drops of oil on the paper to observe the color of the oil and smell the odor, such as the oil is yellow-cream, and no other odor, indicating that the water has entered the crankcase, you should check whether the cylinder gasket is damaged, whether the cylinder water channel Cracked, wet rubber sleeves and cylinder seals are installed correctly or damaged.
If you smell the fuel oil in the automatic generator set engine, you should start the engine to observe whether it is running well. If the exhaust pipe is black smoke after starting the diesel engine, you should check whether the needle valve of the injector is normally closed. If there is any leakage, it should be For maintenance. If the engine is underpowered at normal operating temperature, check whether the plunger of the injection pump is leaking diesel (for gasoline engine, check if the pump pump skin is broken), and the clearance between piston, piston ring and cylinder. Is it too large and replace or overhaul it?
What is the reason for the rise of oil level in the automatic generator set?
Automatic generator set oil level rise, what causes this? This may be caused by the infiltration of water into the oil basin. The specific solutions are described below: